Tiger Winter Maintenance Notes

These are winter maintenance notes for me, but others might find them handy...

Rims:   Front: 36 spoke alloy rim 19 x 2.5"  Rear: 40 spoke alloy rim 17 x 4.25"
2005 Tiger:  14 spoke cast alloy: same size (is this findable?  Yes it is!  Not rears though)

Tires: Front: 110/80-19 Rear: 150/70-17

Coolant flush.  2.8l of coolant (50% distilled water 50% corrosion inhibited ethylene glycol)
- cool engine
- remove fuel tank
- remove pressure cap- 
- unscrew bleed hole bolt (thermostat housing)
- remove reservoir cap
- container under engine
- unscrew drain plug (left side of engine) & drain (keep the old washer for flushing)
- remove lower coolant hose and drain
- flush with tap water
- reinstall old washer & plug & lower coolant hose and fill with water & aluminum friendly rad flush
- reinstall drain plug (25Nm) rad cap and bleed hole bolt (7Nm)
- put fuel tank back on
- run engine to warm (10 mins) then let cool
- re-drain
- refill with plain water, repeat running, cool and redrain
- use a new drain plug washer and torque to 25Nm
- with everything but the bleed bolt installed slowly fill with coolant
- fill reservoir to MAX and cap everything and install bleed bolt (7Nm)
- run 3-4 mins, rev to 4-6k a few times to open it up, check rad and reservoir levels

Spark Plugs:  NGK DPR8EA-9   0.8 to 0.9 gap  20Nm  (under gas tank, like everything else)

Fork oil change:  Kayaba G10 or equivalent 107 mm from top of tube with fork spring removed and leg fully compressed.  Larger riders (like me!) might want 15 weight oil.
Tiger oil change intervals.  Tiger fork oil.
Fork oil viscosity  -  More Tiger fork oil info.
Capacity: 720cc/ml  oil level: 107mm (from top of tube with spring removed and compressed leg)
Removal of forks (with body work & front wheel removed)
- one at a time and with all gubbins removed from fork
- loosen fork clamp bolts
- loosen top fork bolt while it's still on the bike (hard to do when it's off)
- note alignment of fork before removing it
- loosen lower clamp bolts, it should slide loose out the bottom
top fork bolt:  30Nm
clamp bolts top yoke:  20Nm
Handlebar holder clamp bolts:  26Nm

Brake fluid flush   DOT 4

Chassis lubricant (swing arm, stearing head, levers & pedals): Mobile Grease HP 222 or lithium based multi purpose grease.

Scotland and Shetland On Two Wheels

Another piece of fantasy trip planning so I'm ready to go when I become pointlessly rich...  this time Scotland and into the North Sea!

https://goo.gl/maps/Jnmk75iLkJQ2

Two days on the mainland working our way north to the ferry port in Thurso...

TWO WEEKS:  SCOTLAND AND INTO THE NORTH SEA

Day 1:  Ediburgh to Inverbroom Lodge
Day 2: Inverbroom Lodge to Thurso
Day 3: Ferry to Orknies
Day 4: Orkneys day 2
Day 5: Ferry to Shetlands
Day 6-10: Shetlands
Day 11: Ferry back to Aberdeen
Day 12: Aberdeen to Edinburgh
Day 13: Edinburgh

FERRY INFORMATION

http://ca.directferries.com/scrabster_stromness_ferry.htm
Thurso to Orkney Islands: 90 minute crossing: £112

http://ca.directferries.com/kirkwall_lerwick_ferry.htm
Kirkwall, Orkney Islands to Shetlands: 7 hour crossing: £225

http://ca.directferries.com/lerwick_aberdeen_ferry.htm
Shetlands to Aberdeen: 12 hour crossing: £289

ORKNEY ISLANDS

https://goo.gl/maps/MPkfc31sWez

Two nights and two full days on the Orkney Islands... Scara Brae!

SHETLAND ISLANDS

https://goo.gl/maps/vrgh5sT6gDM2

The whole thing on Furkot:

Journey To The End of the Earth

Two weeks beyond John O'Groats...


Things to see:
Scotch!
Haunted Scotland
Beautiful spots

Extending the Canadian Motorcycle Riding Season: Snow Bikes!

The idea of a snowmobile conversion for a motorcycle keeps popping up everywhere this winter.  Timbersled makes just such a thing.  It's seven grand Canadian for the system plus another fifteen hundred for the fitting kit.  The Husqvarna FE501S is a road legal dual sport bike that the kit fits.  They can be found for about twelve grand.  It's a rich man's game but that doesn't stop me from dreaming about it.  For about twenty grand Canadian ($14,900 US) I'd have a year 'round off road specialist that would also get down the road when needed.  The thought of pulling up to a RIDE spotcheck in a blizzard on a plated version of one of these makes me quite happy.  Officer: 'Uh, what's that?'

The KLX250 I tried a while back was so slow with me on it that I felt unsafe on roads.  I couldn't coax it to 100km/hr which meant I had a row of traffic behind me even on country back roads.  The Husky weighs less and has almost three times more horsepower.  Keeping up with traffic on back roads would not be a problem.  Those capabilities mean it'd carry me and some camping gear deep into the countryside in the summer while also being snow-bike convertible in the winter, all for twenty five hundred bucks less than a BMW GS.

A new snowmobile costs sixteen grand or more and only works for a few months of year if you're lucky.  From that point of view a road ready enduro bike with a Timbersled system looks like a more useful and cost effective approach to riding in the snow (and everything else). 

Timbersled Snow Conversion System
http://www.timbersled.com/en-ca/snow-bike/short-track

The Husqvarna FE 501S Dual Sport Motorcycle
http://www.husqvarna-motorcycles.com/ca/off-road/four-stroke/fe-501-1/
http://www.cyclecanadaweb.com/articles/36150/
http://www.cycleworld.com/2015/03/23/beta-500-rs-vs-husqvarna-fe-501-s-vs-ktm-500-exc-dual-sport-motorcycles-comparison-test-motorcycle-review
http://www.blackfootdirect.com/p-11174-2016-husqvarna-fe-501s.aspx

In the snow!

In the desert!

On forest trails!  All on the same bike.

Busy Winter Garage & Kawasaki Industrial Art

I never intended to become hooked on Kawasakis.  The motorcycle fixation of my younger self was always Hondas, but when I finally got into motorcycling it was Kawasakis that kept appearing in the right place at the right time, and they've generally been good to me.  To date I've owned three Kawasakis, two Yamahas and a Triumph; not a Honda in sight.

After selling the Yamaha XS1100 custom project bike last summer I decided to double down on the wounded Concours which, in spite of a lot of work and money spent, wasn't sellable.  When I can ride I ride but when the snow flies I tend to get busy in the garage, and this winter is no different.

The winter garage is a busy garage.  The Tiger's having a rest while I work on the Concours custom.  Before the spring season begins the Tiger'll have new fork oil, spark plugs and a coolant flush.

The Concours is in an unprecedented state of undress.  With the rear end removed and the plastics off it looks like a completely different machine.  Yesterday I removed the coolant reservoir located under the oil cooler behind the front wheel.  It's going to get relocated to the back of the battery box so it's out of the way of rocks being kicked up from the road.  There are a lot of after market options for a coolant reservoir, so finding an alternative that fits well in the new location shouldn't be hard.

The 7 inch round headlight with built in LED indicators showed up from Amazon but I'm still waiting on the tail light.  I'd initially thought of doing some kind of front fairing but now I'm going bare bones with only metal framing to mount the light and minimal instruments.  

I purchased some stainless steel framing and I've been cutting it into muffler mounts and the rear light fairing bracket.  That rear fairing piece is going to be as minimal as possible as well.  Perhaps even a box for the rear light in bare frame.  Visible girder frame pieces are going to become a part of what this will look like when it's finished.

I took the instrument cluster apart to see if any of it was salvageable (it wasn't), but the insides look like something out of the DaVinci Code!

Some 90° brackets on the upper fork clamps has me ready to try some headlight mounting ideas.

Pigeon Forge Motorcycle Base Camp Trip Planning

The Smokey Mountains are a motorcycle Mecca for a reason.

Using a combination of motorcycleroads.com and Furkot.com I've been planning day trips from Pigeon Forge, which seems a sensible place to explore the Smokey Mountains from.  The process can serve as escapism on a foggy, freezing drizzle Boxing Day, or it could be  pre-planning for an inevitable trip.

I've variously daydreamed about driving the Tiger down in a van over the Christmas break to New Orleans and Key West, as well as riding down to The Tail of the Dragon next August for a complete solar eclipse.  There are a lot of good reasons to figure out possible rides for when I'm eventually in the area.

Pigeon Forge is located just south east of Knoxville and offers a great launching point into the Smokey Mountains.  The area around there is covered in desirable roads:



The only trick with a winter trip is changeable weather.  It looks like next week in Pigeon Forge would have been a bit challenging:



It's a roll of the dice going south in the winter but the summer's a sure thing.  Maybe I'll find myself in the Smokey Mountains next summer when the moon hides the sun.

200 KM East Loop

230KM Pigeon Forge low land loop

Pigeon Forge 300km South Smokey Mtn loop

240 KM loopback Dragon's Tail